View Single Post
  #8   (View Single Post)  
Old 1st June 2010
iFrag iFrag is offline
New User
 
Join Date: Jun 2010
Posts: 2
Default

This is the only one I can retrieve at the moment. Somewhere after the pciide lines is where 4.7 boot would lockup with the bytes read error.

Code:
OpenBSD 4.6-stable (GENERIC) #0: Mon May 31 18:12:40 EST 2010
    root@mika.wired.net:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: VIA Eden Processor 1200MHz ("CentaurHauls" 686-class) 1.21 GHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,APIC,SEP,MTRR,PGE,CMOV,PAT,CFLUSH,ACPI,MMX,FXSR,SSE,SSE2,TM,SBF,SSE3,EST,TM2,xTPR
real mem  = 468152320 (446MB)
avail mem = 443731968 (423MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/25/08, BIOS32 rev. 0 @ 0xfa340, SMBIOS rev. 2.3 @ 0xf0000 (33 entries)
bios0: vendor Phoenix Technologies, LTD version "6.00 PG" date 11/25/2008
apm0 at bios0: Power Management spec V1.2 (slowidle)
apm0: AC on, battery charge unknown
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xc7f4
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfc720/208 (11 entries)
pcibios0: bad IRQ table checksum
pcibios0: PCI BIOS has 11 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 5 10 11
pcibios0: PCI Interrupt Router at 000:17:0 ("VIA VT8237 ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0x10000
cpu0 at mainbus0: (uniprocessor)
cpu0: RNG AES AES-CTR SHA1 SHA256 RSA
cpu0: unknown Enhanced SpeedStep CPU, msr 0x04090c0a04000c0a
cpu0: using only highest and lowest power states
cpu0: Enhanced SpeedStep 1201 MHz: speeds: 1600, 533 MHz
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "VIA CN700 Host" rev 0x00
viaagp0 at pchb0: v3
agp0 at viaagp0: aperture at 0xe8000000, size 0x10000000
pchb1 at pci0 dev 0 function 1 "VIA CN700 Host" rev 0x00
pchb2 at pci0 dev 0 function 2 "VIA CN700 Host" rev 0x00
pchb3 at pci0 dev 0 function 3 "VIA PT890 Host" rev 0x00
pchb4 at pci0 dev 0 function 4 "VIA CN700 Host" rev 0x00
pchb5 at pci0 dev 0 function 7 "VIA CN700 Host" rev 0x00
ppb0 at pci0 dev 1 function 0 "VIA VT8377 AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "VIA S3 Unichrome PRO IGP" rev 0x01
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
re0 at pci0 dev 9 function 0 "Realtek 8169SC" rev 0x10: RTL8169/8110SCd (0x1800), irq 5, address 00:30:18:a7:b5:08
rgephy0 at re0 phy 7: RTL8169S/8110S PHY, rev. 2
re1 at pci0 dev 11 function 0 "Realtek 8169SC" rev 0x10: RTL8169/8110SCd (0x1800), irq 10, address 00:30:18:a7:b5:09
rgephy1 at re1 phy 7: RTL8169S/8110S PHY, rev. 2
pciide0 at pci0 dev 15 function 0 "VIA VT6420 SATA" rev 0x80: DMA
pciide0: using irq 11 for native-PCI interrupt
atapiscsi0 at pciide0 channel 0 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <TSSTcorp, CDDVDW SH-S223B, SB02> ATAPI 5/cdrom removable
cd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
wd0 at pciide0 channel 1 drive 0: <WDC WD1600AAJS-00B4A0>
wd0: 16-sector PIO, LBA48, 152627MB, 312581808 sectors
wd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 5
pciide1 at pci0 dev 15 function 1 "VIA VT82C571 IDE" rev 0x06: ATA133, channel 0 configured to compatibility, channel 1 configured to compatibility
pciide1: channel 0 disabled (no drives)
pciide1: channel 1 ignored (disabled)
uhci0 at pci0 dev 16 function 0 "VIA VT83C572 USB" rev 0x81: irq 11
uhci1 at pci0 dev 16 function 1 "VIA VT83C572 USB" rev 0x81: irq 11
uhci2 at pci0 dev 16 function 2 "VIA VT83C572 USB" rev 0x81: irq 11
uhci3 at pci0 dev 16 function 3 "VIA VT83C572 USB" rev 0x81: irq 11
ehci0 at pci0 dev 16 function 4 "VIA VT6202 USB" rev 0x86: irq 5
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "VIA EHCI root hub" rev 2.00/1.00 addr 1
viapm0 at pci0 dev 17 function 0 "VIA VT8237 ISA" rev 0x00
iic0 at viapm0
spdmem0 at iic0 addr 0x50: 1GB DDR2 SDRAM non-parity PC2-4200CL5
auvia0 at pci0 dev 17 function 5 "VIA VT8233 AC97" rev 0x60: irq 5
ac97: codec id 0x414c4760 (Avance Logic ALC655 rev 0)
audio0 at auvia0
usb1 at uhci0: USB revision 1.0
uhub1 at usb1 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb2 at uhci1: USB revision 1.0
uhub2 at usb2 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb3 at uhci2: USB revision 1.0
uhub3 at usb3 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb4 at uhci3: USB revision 1.0
uhub4 at usb4 "VIA UHCI root hub" rev 1.00/1.00 addr 1
isa0 at mainbus0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: probed fifo depth: 15 bytes
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
com1: probed fifo depth: 15 bytes
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
fins0 at isa0 port 0x4e/2
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
biomask fb65 netmask ff65 ttymask ffff
mtrr: Pentium Pro MTRR support
uhidev0 at uhub2 port 1 configuration 1 interface 0 "Dell Dell USB Keyboard" rev 1.10/3.01 addr 2
uhidev0: iclass 3/1
ukbd0 at uhidev0: 8 modifier keys, 6 key codes
wskbd1 at ukbd0 mux 1
wskbd1: connecting to wsdisplay0
uhidev1 at uhub1 port 2 configuration 1 interface 0 "Logitech USB-PS/2 Optical Mouse" rev 2.00/22.00 addr 2
uhidev1: iclass 3/1
ums0 at uhidev1: 8 buttons, Z dir
wsmouse0 at ums0 mux 0
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
Reply With Quote