View Single Post
Old 7th July 2011
jggimi's Avatar
jggimi jggimi is offline
More noise than signal
 
Join Date: May 2008
Location: USA
Posts: 7,977
Default

Quote:
Originally Posted by sepuku View Post
If i follow your steps in the ukc prompt,when i press "quit" the system is halted...
Then disabling ACPI will not work for you.
Quote:
... and i have to reboot to continue and then i get the same errors.
Of course, because ACPI is active once more.
Quote:
Then booted the UKC prompt,just typed quit,all devices where read by the system and I managed to see Install,Upgrade,Shell: i installed succesfully and after reboot i got the same error.
That behavior, as described, does not make a great deal of sense to me, unless there is some sort of race condition that is avoided by prompting the admin.
Quote:
Then i did the same again:booted the ukc,just typed quit: went to shell but i have no config: "sh: config: not found" :/
Did you boot the installed system, or the RAMDISK kernel once more? The config program is not available in the RAMDISK environment. It is a very reduced system, used for installation and some "offline" operations and has only limited tools.

But, config will not help you, since it appears disabling ACPI halts the system.
Reply With Quote