Quote:
Originally Posted by sepuku
If i follow your steps in the ukc prompt,when i press "quit" the system is halted...
|
Then disabling ACPI will not work for you.
Quote:
... and i have to reboot to continue and then i get the same errors.
|
Of course, because ACPI is active once more.
Quote:
Then booted the UKC prompt,just typed quit,all devices where read by the system and I managed to see Install,Upgrade,Shell: i installed succesfully and after reboot i got the same error.
|
That behavior, as described, does not make a great deal of sense to me, unless there is some sort of race condition that is avoided by prompting the admin.
Quote:
Then i did the same again:booted the ukc,just typed quit: went to shell but i have no config: "sh: config: not found" :/
|
Did you boot the installed system, or the RAMDISK kernel once more? The config program is not available in the RAMDISK environment. It is a very reduced system, used for installation and some "offline" operations and has only limited tools.
But, config will not help you, since it appears disabling ACPI halts the system.