works ok with single drive connected
I disconnected the two other drives so that only the single SATA drive with the Vista/FreeBSD on it is hooked up. As I expected the dual boot completes normally in this scenario as before. If someone can shed some light on the mountroot> prompt which comes up with the other drives connected and what needs to be entered here, it would be much appreciated. Also I am at a loss of what to do to avoid the long sequence of codes which appear on each startup of FreeBSD (more than a minute delay).
I was unable to figure out how to sign in as admin so that I could change the write permissions for device.hints
Although I installed with default QWERTY keyboard, I also have problems with getting " when I try to type @. Is there a way to change this?
Good luck with your laptop order Dazhelpwiz
Last edited by archp2008; 20th June 2008 at 03:51 PM.
|