Hi ldOp !
Thanks for the checklist .. helpful for a newbie ..
* less /etc/resolv.conf
Code:
# Created by dhclient from wpi0
nameserver 192.168.1.1
* /etc/rc.conf
Code:
rc_configured=YES
# Add local overrides below
#
wscons=YES
sshd=YES
dhclient=YES
defaultroute=192.168.1.1
pf=NO
*#route -n show -inet
Code:
Routing table
Internet:
Destination Gateway Flags
default 192.168.1.1 UG
127.0.0.0/8 127.0.0.1 UGR
127.0.0.1 127.0.0.1 UH
192.168.1.0/24 link#1 U
192.168.1.1 00:80:5a:5a:36:32 UHL
192.168.1.2 127.0.0.1 UGH
* ifconfig -a
Code:
wpi0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
ssid Conceptronic
powersave off
bssid 00:80:5a:5a:36:33 chan 6
address: 00:19:d2:28:eb:bc
media: IEEE802.11 autoselect (OFDM36 mode 11g)
status: active
inet 192.168.1.2 netmask 0xffffff00 broadcast 192.168.1.255
inet6 fe80::219:d2ff:fe28:ebbc%wpi0 prefixlen 64 scopeid 0x1
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 33192
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2
* did you enable any packet filtering?
no I didn't .. and pf is set to no in rc.conf
* dmesg ? ...