Thanks for the advice on ifconfig. Below is the result for Ubuntu and the addresses for eth1 are the same as those for OpenBSD 4.6.
Code:
eth0 Link encap:Ethernet HWaddr 00:25:64:04:50:e9
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:253 Base address:0xa000
eth1 Link encap:Ethernet HWaddr 00:08:0e:c5:d0:e3
inet addr:67........ Bcast:67......... Mask:255.........
inet6 addr: fe80::208:eff:fec5:d0e3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:338 errors:0 dropped:0 overruns:0 frame:0
TX packets:35 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:18804 (18.8 KB) TX bytes:5280 (5.2 KB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:480 (480.0 B) TX bytes:480 (480.0 B)
Following is the result of OpenBSD ifconfig. Since I could not print it out, I copied what I thought was necessary.
Code:
re0 flags=8843<up,broadcast,running,simplex,multicast> mtu 1500
lladder all0
media: ethernet autoselect (none)
status: no carrier
inet 67........ Mask:hex Bcast:67.........
cdce0 flags=8843<up,broadcast,running,simplex,multicast> mtu 1500
groups: dhcp egress
inet 67........ Mask:hex(different than re0) Bcast:67.........
I loaded OpenBSD two different ways since my posting. First I configured just the cable modem. Next I configured both the cable modem, cdce0, using dhcp, and the ethernet card, re0, using addresses from Ubuntu. I could ping websites,
but I could not get into the OpenBSD ftp site to obtain packages (not found). But with both of the above mentioned loading methods I could get into a FreeBSD site. I was connected to moss.cse.buffaloedu. This is one reason I didn't
include the above information completely. I forgot to enter echo $pkg_path. To get to this forum I have to reload Ubuntu.
Tanks again.