I installed OpenBSD 5.3 snapshots on my Sun Blade 2500.
OpenBoot PROM 4.17.1 ok
dmesg :
Code:
console is keyboard/display
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2013 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 5.3 (GENERIC) #37: Fri Mar 1 12:03:14 MST 2013
deraadt@sparc64.openbsd.org:/usr/src/sys/arch/sparc64/compile/GENERIC
real mem = 4294967296 (4096MB)
avail mem = 4213784576 (4018MB)
mainbus0 at root: Sun Blade 2500
cpu0 at mainbus0: SUNW,UltraSPARC-IIIi (rev 2.4) @ 1280 MHz
cpu0: physical 32K instruction (32 b/l), 64K data (32 b/l), 1024K external (64 b/l)
"memory-controller" at mainbus0 not configured
schizo0 at mainbus0: "Tomatillo", version 4, ign 700, bus A 0 to 0
schizo0: dvma map c0000000-dfffffff
pci0 at schizo0
bge0 at pci0 dev 3 function 0 "Broadcom BCM5703" rev 0x00, BCM5702/5703 A2 (0x1002): ivec 0x71c, address 00:03:ba:8c:19:6b
brgphy0 at bge0 phy 1: BCM5703 10/100/1000baseT PHY, rev. 2
"ppm" at mainbus0 not configured
schizo1 at mainbus0: "Tomatillo", version 4, ign 740, bus B 0 to 0
schizo1: dvma map c0000000-dfffffff
pci1 at schizo1
siop0 at pci1 dev 4 function 0 "Symbios Logic 53c1010-66" rev 0x01: ivec 0x769, using 8K of on-board RAM
scsibus0 at siop0: 16 targets, initiator 7
sd0 at scsibus0 targ 0 lun 0: <FUJITSU, MAJ3364MC, 3702> SCSI2 0/direct fixed serial.FUJITSU_MAJ3364MC_00000479
sd0: 34858MB, 512 bytes/sector, 71390320 sectors
siop1 at pci1 dev 4 function 1 "Symbios Logic 53c1010-66" rev 0x01: ivec 0x768, using 8K of on-board RAM
scsibus1 at siop1: 16 targets, initiator 7
schizo2 at mainbus0: "Tomatillo", version 4, ign 780, bus A 0 to 1
schizo2: dvma map c0000000-dfffffff
pci2 at schizo2
ebus0 at pci2 dev 7 function 0 "Acer Labs M1533 ISA" rev 0x00
"flashprom" at ebus0 addr 0-fffff not configured
rtc0 at ebus0 addr 70-71: m5823
pcfiic0 at ebus0 addr 320-321 ivec 0x2e
iic0 at pcfiic0
"SUNW,i2c-imax" at iic0 addr 0x9 not configured
"pca9556" at iic0 addr 0x18 not configured
admtt0 at iic0 addr 0x2c
admtt1 at iic0 addr 0x2e
"fm3560" at iic0 addr 0x37 not configured
"fm3560" at iic0 addr 0x4e not configured
spdmem0 at iic0 addr 0x5b: 1GB DDR SDRAM registered ECC PC2300CL2.5
spdmem1 at iic0 addr 0x5c: 1GB DDR SDRAM registered ECC PC2300CL2.5
spdmem2 at iic0 addr 0x5d: 1GB DDR SDRAM registered ECC PC2300CL2.5
spdmem3 at iic0 addr 0x5e: 1GB DDR SDRAM registered ECC PC2300CL2.5
"ics951601" at iic0 addr 0x69 not configured
power0 at ebus0 addr 800-82f ivec 0x20
com0 at ebus0 addr 3f8-3ff ivec 0x2c: ns16550a, 16 byte fifo
com1 at ebus0 addr 2e8-2ef ivec 0x2c: ns16550a, 16 byte fifo
"dma" at ebus0 addr 0-ffff not configured
alipm0 at pci2 dev 6 function 0 "Acer Labs M7101 Power" rev 0x00: 223KHz clock
iic1 at alipm0
"scm001" at alipm0 addr 0x20 skipped due to alipm0 bugs
autri0 at pci2 dev 8 function 0 "Acer Labs M5451 Audio" rev 0x02: ivec 0x7a4
ac97: codec id 0x41445348 (Analog Devices AD1881A)
ac97: codec features headphone, Analog Devices Phat Stereo
audio0 at autri0
midi0 at autri0: <4DWAVE MIDI UART>
ohci0 at pci2 dev 10 function 0 "Acer Labs M5237 USB" rev 0x03: ivec 0x7a7, version 1.0, legacy support
ohci1 at pci2 dev 11 function 0 "Acer Labs M5237 USB" rev 0x03: ivec 0x7a6, version 1.0, legacy support
pciide0 at pci2 dev 13 function 0 "Acer Labs M5229 UDMA IDE" rev 0xc4: DMA, channel 0 configured to native-PCI, channel 1 configured to native-PCI
pciide0: using ivec 0x798 for native-PCI interrupt
pciide0: channel 0 disabled (no drives)
atapiscsi0 at pciide0 channel 1 drive 0
scsibus2 at atapiscsi0: 2 targets
cd0 at scsibus2 targ 0 lun 0: <ASUS, CRW-5232AS, 1.0> ATAPI 5/cdrom removable
cd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
ppb0 at pci2 dev 4 function 0 "TI PCI2250 PCI-PCI" rev 0x02
pci3 at ppb0 bus 1
ohci2 at pci3 dev 8 function 0 "NEC USB" rev 0x43: ivec 0x794, version 1.0
ohci3 at pci3 dev 8 function 1 "NEC USB" rev 0x43: ivec 0x795, version 1.0
ehci0 at pci3 dev 8 function 2 "NEC USB" rev 0x04: ivec 0x796
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "NEC EHCI root hub" rev 2.00/1.00 addr 1
"TI TSB43AB23 FireWire" rev 0x00 at pci3 dev 11 function 0 not configured
usb1 at ohci2: USB revision 1.0
uhub1 at usb1 "NEC OHCI root hub" rev 1.00/1.00 addr 1
usb2 at ohci3: USB revision 1.0
uhub2 at usb2 "NEC OHCI root hub" rev 1.00/1.00 addr 1
usb3 at ohci0: USB revision 1.0
uhub3 at usb3 "Acer Labs OHCI root hub" rev 1.00/1.00 addr 1
usb4 at ohci1: USB revision 1.0
uhub4 at usb4 "Acer Labs OHCI root hub" rev 1.00/1.00 addr 1
"ppm" at mainbus0 not configured
schizo3 at mainbus0: "Tomatillo", version 4, ign 7c0, bus B 0 to 0
schizo3: dvma map c0000000-dfffffff
pci4 at schizo3
ifb0 at pci4 dev 2 function 0 "3D Labs Wildcat 5110" rev 0x01
ifb0: XVR-600 (SUNW,375-3153), 1280x1024
wsdisplay0 at ifb0 mux 1: console (std, sun emulation)
"i2c" at mainbus0 not configured
siop0: target 0 now using tagged DT 16 bit 80.0 MHz 62 REQ/ACK offset xfers
uhidev0 at uhub4 port 1 configuration 1 interface 0 "vendor 0x04f3 product 0x0103" rev 2.00/1.07 addr 2
uhidev0: iclass 3/1
ukbd0 at uhidev0: 8 variable keys, 6 key codes
wskbd0 at ukbd0: console keyboard, using wsdisplay0
uhidev1 at uhub4 port 1 configuration 1 interface 1 "vendor 0x04f3 product 0x0103" rev 2.00/1.07 addr 2
uhidev1: iclass 3/0, 2 report ids
uhid0 at uhidev1 reportid 1: input=2, output=0, feature=0
uhid1 at uhidev1 reportid 2: input=1, output=0, feature=0
vscsi0 at root
scsibus3 at vscsi0: 256 targets
softraid0 at root
scsibus4 at softraid0: 256 targets
bootpath: /pci@1d,700000/scsi@4,0/disk@0,0
root on sd0a (0748731b9b78af04.a) swap on sd0b dump on sd0b
Everything works, but the shell screen is awful, black text on white screen.
And the Sun XVR600 graphic card can display 1900x1020, but only works in 8-bit mode, ans is REALLY SLOW
Ethernet ok
IDE CDROM ok
Generic USB keyboard ok
Generic USB mouse ok
Installed a Fujitsu SCSI Ultra160 HDD, ok
Tried some environnements :
startx fvwm passed
xfce4 passed
kde failed
KDE can be launched, but I only get the splash-screen and the mouse cursor, and nothing else.
No login screen, no waiting mouse cursor, and nothing else !
Now I must dig the log...