Quote:
Originally Posted by BSDfan666
It could be a userland PPPoE vs kernel PPPoE issue, which do you use in your configuration?
|
If you mean on the router, it came pre-provisioned. I just went in and changed its internal network IP address. But this is off the web config page:
HTML Code:
VPI/VCI VLAN Mux Con. ID Category Service Interface Protocol Igmp Nat Firewall QoS State Remove Edit
0/32 Off 1 UBR pppoa_0_0_32_1 ppp_0_0_32_1 PPPoA Disabled Enabled Disabled Disabled Enabled
If you mean the firewall, it's just a default install. I've changed nothing except interface names and the packet forwarding sysctl. Does this help?
thanks,
tf