When presenting output from your display,
please place the output between code tags
([code] before, & [/code] afterward...) as this will preserve formating.
As an example compare the following:
- lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 33208
groups: lo
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:1b:21:0f:8b:43
groups: egress
media: Ethernet autoselect (100baseTX full-duplex)
status: active
inet6 fe80::21b:21ff:fe0f:8b43%em0 prefixlen 64 scopeid 0x1
inet 192.168.0.6 netmask 0xffffff00 broadcast 192.168.0.255
fxp0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:90:27:a7:50:80
media: Ethernet autoselect (none)
status: no carrier
enc0: flags=0<> mtu 1536
-
Code:
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 33208
groups: lo
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:1b:21:0f:8b:43
groups: egress
media: Ethernet autoselect (100baseTX full-duplex)
status: active
inet6 fe80::21b:21ff:fe0f:8b43%em0 prefixlen 64 scopeid 0x1
inet 192.168.0.6 netmask 0xffffff00 broadcast 192.168.0.255
fxp0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:90:27:a7:50:80
media: Ethernet autoselect (none)
status: no carrier
enc0: flags=0<> mtu 1536