Sorry if I didn't clearly mentioned it, I did not connect yet the re1 card, that's why it has no active link. When I plug re1 it becomes active, but I still have no network access.
I switched the IP addresses between re0 and re1, and unplugged re0, to plug re1 (ifconfig extract) :
Quote:
re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 80:ee:73:83:50:e0
priority: 0
media: Ethernet autoselect (none)
status: no carrier
inet 10.0.0.1 netmask 0xffffff00 broadcast 10.0.0.255
inet6 fe80::82ee:73ff:fe83:50e0%re0 prefixlen 64 scopeid 0x1
re1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 80:ee:73:83:50:ec
priority: 0
groups: egress
media: Ethernet autoselect (100baseTX full-duplex,rxpause,txpause)
status: active
inet 192.168.1.70 netmask 0xffffff00 broadcast 192.168.1.255
inet6 fe80::82ee:73ff:fe83:50ec%re1 prefixlen 64 scopeid 0x2
|
I rebooted, the routes were correct, the default became re1, but it didn't correct the problem.
EDIT : I connected both re0 and re1 at the same time, both becomes active, but still no network, even after a reboot.