Quote:
Originally Posted by wlm2
...when the board is after the installation process, is not detecting the installation drive.
Code:
01F0 Master 044A CF CARD 4GB
Phys C/H/S 1966/16/63 Log C/H/S 983/32/63
Using drive 0, partition 3;
Loading;...
probing: pc0 com0 pci mem[640K 255M a20=on]
disk: hd0
>> OpenBSD/i386 BOOT 3.01
boot>
booting hd0a:/bsd: 5665588+872060 [52+291168+272312]=0x6c5c70
entry point at 0x200120
|
First of all, welcome!
I assume you are connecting to the board via a serial cable. If so, you are probably wanting to change system output to a serial console rather than the default
(keyboard & monitor). Serial consoles are enabled during installation by answering
"yes" to the displayed question:
Code:
Change the default console to com0? [no]
When answered
"yes", you will then be prompted for the baud rate. I l believe this will be 38400 as with the Alix2 series, but you should verify on PC Engines'
Website.
More information & context on the installation process can be found in
Section 4.5.2 of the FAQ.