Here is what I get when I do a smartctl -a
Code:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 084 069 006 Pre-fail Always - 0
3 Spin_Up_Time 0x0003 096 093 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 99
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 8
7 Seek_Error_Rate 0x000f 045 045 030 Pre-fail Always - 9629385353742
9 Power_On_Hours 0x0032 099 099 000 Old_age Always - 1492
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 153
187 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 0
189 Unknown_Attribute 0x003a 100 100 000 Old_age Always - 0
190 Temperature_Celsius 0x0022 054 040 045 Old_age Always In_the_past 774111278
194 Temperature_Celsius 0x0022 046 060 000 Old_age Always - 46 (Lifetime Min/Max 0/23)
195 Hardware_ECC_Recovered 0x001a 071 055 000 Old_age Always - 51827
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 1
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 1
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
200 Multi_Zone_Error_Rate 0x0000 100 253 000 Old_age Offline - 0
202 TA_Increase_Count 0x0032 100 253 000 Old_age Always - 0
SMART Error Log Version: 1
No Errors Logged
some of those numbers look just.. um.. wrong. Gonna run the test again.
=(.