View Single Post
  #5   (View Single Post)  
Old 22nd August 2012
jggimi's Avatar
jggimi jggimi is offline
More noise than signal
 
Join Date: May 2008
Location: USA
Posts: 7,977
Default

x11/dbus fails to build because X11/Xlib.h is missing. This is in the xshare51.tgz fileset.

The xbase fileset is needed to run packages, but in general, all of X should be installed before you begin to build ports.

----
Edited to add this quote from FAQ 15.4.1:
Quote:
Another common failure is a missing X11 installation. Even if the port you try to build has no direct dependency on X11, a subpackage of it or its dependencies may require X11 headers and libraries. Building ports on systems without X11 is not supported, so if you insist on doing so, you are on your own to figure it out.

Last edited by jggimi; 22nd August 2012 at 11:51 AM. Reason: addendum
Reply With Quote