Using the Cd and entering on the system using the Shell i noted one thing strange.
During the installation was said i have two hdd:
wd0 (my main hdd with linux partions)
wd1 (my secondary hdd where i have put openbsd)
While entering i don't found wd1.
#disklabel rd0
Code:
# /dev/rrd0c:
type: unknown
disk: rdroot
label:
duid: 81cf6d344b7cfed7
flags:
bytes/sector: 512
sectors/track: 128
tracks/cylinder: 2
sectors/cylinder: 256
cylinders: 16
total sectors: 3872
boundstart: 0
boundend: 3872
drivedata: 0
3 partitions:
# size offset fstype [fsize bsize cpg]
a: 3872 0 4.2BSD 512 4096 1
c: 3872 0 unused
#fdisk rd0
Code:
Disk: rd0 geometry: 1/1/3872 [3872 Sectors]
Offset: 0 Signature: 0x0
Starting Ending LBA Info:
#: id C H S - C H S [ start: size ]
-------------------------------------------------------------------------------
0: 00 0 0 0 - 0 0 0 [ 0: 0 ] unused
1: 00 0 0 0 - 0 0 0 [ 0: 0 ] unused
2: 00 0 0 0 - 0 0 0 [ 0: 0 ] unused
3: 00 0 0 0 - 0 0 0 [ 0: 0 ] unused
So i make:
#fdisk -u rd0
but during the boot don't start the same.
Now i made another update-grub from linux but on the generation of the grub2 i don't see the same the voice for openbsd.
I made a restart and, naturally, don't work.
I don't understand what happened.
On this secondary hdd for remove linux during the installation i said use the Whole disc while from the above command seem that the partition for openbsd was created but i don't see any partition inside it.
Inside the dmesg I have wd1 for the secondary hdd:
Quote:
wd1 at pciide0 channel 0 drive 1: <FUJITSU MPD3064AT>
wd1: 16-sector PIO, LBA, 6187MB, 12672450 sectors
wd1(pciide0:0:1): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4
|