View Single Post
Old 20th January 2010
J65nko J65nko is offline
Administrator
 
Join Date: May 2008
Location: Budel - the Netherlands
Posts: 3,766
Default

With a serial cable the logging of these messages is very easy. Here is a sample:
Code:
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
usb3 at uhci0: USB revision 1.0
uhub3 at usb3 "Intel UHCI root hub" rev 1.00/1.00 addr 1
usb4 at uhci1: USB revision 1.0
uhub4 at usb4 "Intel UHCI root hub" rev 1.00/1.00 addr 1
rd0: fixed, 3800 blocks
softraid0 at root
root on rd0a swap on rd0b dump on rd0b
erase ^?, werase ^W, kill ^U, intr ^C, status ^T

Welcome to the OpenBSD/i386 4.5 installation program.
(I)nstall, (U)pgrade or (S)hell? i

Cool! Let's get to it.

At any prompt except password prompts you can escape to a shell by
typing '!'. Default answers are shown in []'s and are selected by
pressing RETURN.  You can exit this program at any time by pressing
Control-C, but this can leave your system in an inconsistent state.

Terminal type? [vt220]
System hostname? (short form, e.g. 'foo') vintrax

Available network interfaces are: fxp0 vlan0.
Which one do you wish to configure? (or 'done') [fxp0]
IPv4 address for fxp0? (or 'dhcp' or 'none') [dhcp] 192.168.222.244
Netmask? [255.255.255.0]
IPv6 address for fxp0? (or 'rtsol' or 'none') [none]
Available network interfaces are: fxp0 vlan0.
Which one do you wish to configure? (or 'done') [done]
Default IPv4 route? (IPv4 address, 'dhcp' or 'none') 192.168.222.10
add net default: gateway 192.168.222.10
I am not going to pass this request on, I am not even considering it, because I know, I would get an answer like this:
"Why should OpenBSD developers spend their precious time, to make things easier for lazy people"
__________________
You don't need to be a genius to debug a pf.conf firewall ruleset, you just need the guts to run tcpdump
Reply With Quote