View Single Post
Old 27th July 2008
twisted_steel twisted_steel is offline
Port Guard
 
Join Date: May 2008
Posts: 12
Default

My new box is up and running. I used the VIA EPIA LN10000EG Mini-ITX Mainboard with 1GB of RAM and a 160GB 2.5" HDD. Installation was done using PXE Boot and the 4.3 'pxeboot' image. I did a full recompile for 4.3-stable on the box in just over 3 hours.

Here is the dmesg:

Quote:
OpenBSD 4.3-stable (GENERIC) #0: Sat Jul 26 13:50:52 UTC 2008
root@<host.domain>:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: VIA Esther processor 1000MHz ("CentaurHauls" 686-class) 1 GHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,P GE,CMOV,PAT,CFLUSH,ACPI,MMX,FXSR,SSE,SSE2,TM,SBF,S SE3,EST,TM2
cpu0: RNG AES AES-CTR SHA1 SHA256 RSA
real mem = 1005023232 (958MB)
avail mem = 963633152 (918MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/19/07, BIOS32 rev. 0 @ 0xf9440, SMBIOS rev. 2.3 @ 0xf0000 (24 entries)
apm0 at bios0: Power Management spec V1.2 (slowidle)
apm0: AC on, battery charge unknown
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xc594
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfc500/144 (7 entries)
pcibios0: bad IRQ table checksum
pcibios0: PCI BIOS has 7 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 5 10 11
pcibios0: PCI Interrupt Router at 000:17:0 ("VIA VT8237 ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0xfc00 0xd0000/0x2000
cpu0 at mainbus0
cpu0: unknown Enhanced SpeedStep CPU, msr 0x08100a1308000a13
cpu0: using only highest and lowest power states
cpu0: Enhanced SpeedStep 1000 MHz (1004 mV): speeds: 1000, 800 MHz
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "VIA CN700 Host" rev 0x00
agp0 at pchb0: v3, aperture at 0xe8000000, size 0x10000000
pchb1 at pci0 dev 0 function 1 "VIA CN700 Host" rev 0x00
pchb2 at pci0 dev 0 function 2 "VIA CN700 Host" rev 0x00
pchb3 at pci0 dev 0 function 3 "VIA PT890 Host" rev 0x00
pchb4 at pci0 dev 0 function 4 "VIA CN700 Host" rev 0x00
pchb5 at pci0 dev 0 function 7 "VIA CN700 Host" rev 0x00
ppb0 at pci0 dev 1 function 0 "VIA VT8377 AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "VIA S3 Unichrome PRO IGP" rev 0x01
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
pciide0 at pci0 dev 15 function 0 "VIA VT6420 SATA" rev 0x80: DMA
pciide0: using irq 11 for native-PCI interrupt
wd0 at pciide0 channel 1 drive 0: <WDC WD1600BEVS-07RST0>
wd0: 16-sector PIO, LBA48, 152627MB, 312581808 sectors
wd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 5
pciide1 at pci0 dev 15 function 1 "VIA VT82C571 IDE" rev 0x06: ATA133, channel 0 configured to compatibility, channel 1 configured to compatibility
pciide1: channel 0 disabled (no drives)
pciide1: channel 1 disabled (no drives)
uhci0 at pci0 dev 16 function 0 "VIA VT83C572 USB" rev 0x81: irq 10
uhci1 at pci0 dev 16 function 1 "VIA VT83C572 USB" rev 0x81: irq 10
uhci2 at pci0 dev 16 function 2 "VIA VT83C572 USB" rev 0x81: irq 11
uhci3 at pci0 dev 16 function 3 "VIA VT83C572 USB" rev 0x81: irq 11
ehci0 at pci0 dev 16 function 4 "VIA VT6202 USB" rev 0x86: irq 5
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "VIA EHCI root hub" rev 2.00/1.00 addr 1
viapm0 at pci0 dev 17 function 0 "VIA VT8237 ISA" rev 0x00
iic0 at viapm0
spdmem0 at iic0 addr 0x50: 1GB DDR2 SDRAM non-parity PC2-5300CL5
auvia0 at pci0 dev 17 function 5 "VIA VT8233 AC97" rev 0x60: irq 5
ac97: codec id 0x56494183 (VIA Technologies <83>)
ac97: codec features 18 bit DAC, 18 bit ADC, No 3D Stereo
audio0 at auvia0
vr0 at pci0 dev 18 function 0 "VIA RhineII-2" rev 0x78: irq 10, address 00:40:63:f6:32:3b
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 10: OUI 0x004063, model 0x0032
usb1 at uhci0: USB revision 1.0
uhub1 at usb1 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb2 at uhci1: USB revision 1.0
uhub2 at usb2 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb3 at uhci2: USB revision 1.0
uhub3 at usb3 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb4 at uhci3: USB revision 1.0
uhub4 at usb4 "VIA UHCI root hub" rev 1.00/1.00 addr 1
isa0 at mainbus0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
viasio0 at isa0 port 0x2e/2: VT1211 rev 0x02, HM, WDG not activated
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
biomask ff6d netmask ff6d ttymask ffef
softraid0 at root
root on wd0a swap on wd0b dump on wd0b

Last edited by twisted_steel; 27th July 2008 at 12:40 PM. Reason: Added some more info to the top
Reply With Quote