View Single Post
Old 28th July 2009
jggimi's Avatar
jggimi jggimi is offline
More noise than signal
 
Join Date: May 2008
Location: USA
Posts: 7,977
Default

Quote:
Originally Posted by plexter View Post
That is the complete routing table using your command. I simply added tun0 to simplify removing the private addresses...
I was interested in the complete list of directly connected subnets and remotely connected addresses, so that I could understand the entire routing table. By private address, I meant any addresses actually exposed to the Internet -- so that someone who saw a configuration problem would not be able to exploit it immediately. Since your gateway appears to use an RFC1918 address, it looks to me that your entire network falls within RFC1918 and NAT is managed by your ISP.

One thing I did note; your default route points to your local end (20.1) of the ppp connection rather than the remote end (20.2). I don't know if this is a ppp or pppoe specific requirement, but it seems wrong to me.
Reply With Quote