Quote:
|
Doesn't seem to be synapsis based. But thanks for the heads up.
|
The driver supports Synaptics and ALPS touchpads for certain and likely ElanTech.
It would be easy to test by enabling a parameter (tap to click is not enabled by default) which I think you can do directly from the command line. An example is
here
Edit: I looked at your dmesg and the touchpad driver is not being recognized
Quote:
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
|
My dmesg:
Quote:
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pms0: Synaptics touchpad, firmware 5
|
Yet it sounds like it is recognized. Can you do two finger scrolling ?(enable by default) on most touch pads?