23rd October 2008
|
 |
Administrator
|
|
Join Date: Apr 2008
Location: pl_PL.lodz
Posts: 1,056
|
|
Quote:
Originally Posted by J65nko
1.3 Determine the partition label
After inserting an USB hard disk, we see the following in '/var/log/messages':
Code:
umass0 at uhub0 port 3 configuration 1 interface 0
umass0: Prolific Technology Inc. Mass Storage Device, rev 2.00/1.00, addr 2
umass0: using SCSI over Bulk-Only
scsibus1 at umass0: 2 targets
sd0 at scsibus1 targ 1 lun 0: <HTS42404, 0M9AT00, MA2O> SCSI0 0/direct fixed
sd0: 38154MB, 4864 cyl, 255 head, 63 sec, 512 bytes/sec, 78140160 sec total
|
You may add info to use tail -f /var/log/messages to check new info in dmesg, in generall:
1.3.1 start tail -f ...
1.3.2 attach USB ...
__________________
religions, worst damnation of mankind
"If 386BSD had been available when I started on Linux, Linux would probably never had happened." Linus Torvalds
Linux is not UNIX! Face it! It is not an insult. It is fact: GNU is a recursive acronym for “GNU's Not UNIX”.
vermaden's: links resources deviantart spreadbsd
|