Ok a little further
I'm sure this will engage someone into slapping some sense into me.
I have been playing around a little and it appears that if I put my hostname file into dhcp rather than fixed the ssh login is fluent. When I put it back to my config above it halts on login. I'm sure this is basic so any ideas would be greatly appreciated.
Below is my dhcp info above is my fixed info (maybe my fixed info has something incorrect).
# dhclient xl0
DHCPDISCOVER on xl0 to 255.255.255.255 port 67 interval 1
DHCPOFFER from 192.168.1.254 (00:19:e4:a2:74:29)
DHCPREQUEST on xl0 to 255.255.255.255 port 67
DHCPACK from 192.168.1.254 (00:19:e4:a2:74:29)
bound to 192.168.1.64 -- renewal in 43200 seconds.
#
# ifconfig
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 33200
priority: 0
groups: lo
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
rl0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:30:bd:07:90:af
priority: 0
media: Ethernet autoselect
status: no carrier
xl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:b0:d0:b9:25:e7
priority: 0
groups: egress
media: Ethernet autoselect (100baseTX full-duplex)
status: active
inet6 fe80::2b0:d0ff:feb9:25e7%xl0 prefixlen 64 scopeid 0x2
inet 192.168.1.64 netmask 0xffffff00 broadcast 192.168.1.255
enc0: flags=0<> mtu 1536
priority: 0
pflog0: flags=141<UP,RUNNING,PROMISC> mtu 33200
priority: 0
groups: pflog
Cheers
Pico
|