Quote:
Originally Posted by ocicat
No. - As jggimi has stated (& as seen in the output of dmesg(8)...), your USB device is connected as sd1.
- Next, use disklabel(8) find the correct partition to mount:
$ sudo disklabel sd1
- If this USB drive is formatted as MS-DOS, usually this will be assigned to partition "i".
- Once the correct partition has been identified, mount it with the following command:
$ sudo mount -t msdos /dev/sd1i /mnt
- Upon success, you should now see this in the output of df(1).
|
You're right.
Code:
# disklabel sd1
# /dev/rsd1c:
type: SCSI
disk: SCSI disk
label: USB DISK 2.0
duid: 0000000000000000
flags:
bytes/sector: 512
sectors/track: 63
tracks/cylinder: 255
sectors/cylinder: 16065
cylinders: 950
total sectors: 15269888
boundstart: 0
boundend: 15269888
drivedata: 0
16 partitions:
# size offset fstype [fsize bsize cpg]
c: 15269888 0 unused
i: 15267840 2048 NTFS
# sudo mount -t msdos /dev/sd1i /mnt
mount_msdos: /dev/sd1i on /mnt: not an MSDOS filesystem
#
Code:
not an MSDOS filesystem
This is the problem.