I see no kernel messages in the xconsole when running
Code:
$ sudo fdisk sd0
Password:
Disk: sd0 geometry: 30400/255/63 [488378646 4096-byte Sectors]
Offset: 0 Signature: 0xAA55
Starting Ending LBA Info:
#: id C H S - C H S [ start: size ]
-------------------------------------------------------------------------------
0: 07 0 1 1 - 243200 254 63 [ 63: 3907024002 ] NTFS
1: 00 0 0 0 - 0 0 0 [ 0: 0 ] unused
2: 00 0 0 0 - 0 0 0 [ 0: 0 ] unused
3: 00 0 0 0 - 0 0 0 [ 0: 0 ] unused
I think i lost all hope right now. :/
I only see these kernel messages when attaching the disk:
Code:
umass0 at uhub0 port 1 configuration 1 interface 0 "JMicron USB to ATA/ATAPI bridge" rev 2.00/1.00 addr 2
umass0: using SCSI over Bulk-Only
scsibus1 at umass0: 2 targets, initiator 0
sd0 at scsibus1 targ 1 lun 0: <ST2000DL, 001-9VT156, > SCSI2 0/direct fixed
sd0: 1907729MB, 4096 bytes/sec, 488378646 sec total