Quote:
Originally Posted by jggimi
That's been evident all along.
|
That's because i'm not hiding it.
Quote:
Originally Posted by jggimi
This requires an MBR partition table too. You will need two MBR partitions: one of type 0x0B or 0x0C for your FAT32 partition, another of type 0xA6 for your OpenBSD partition(s). Your "k" partition would map to the same sectors as the A6 MBR partition, if it is the only BSD partition on the drive.
|
OOoh is see. Well still
fdisk -e sd0 is unable to read MBR.(this happens only with this disk;with wd0 works fine.Also when i try to save the changes i make it says "no label changes" although in 'disklabel sd0' i see the changes.
I think the disk is useful only for recycling right now.