My home router/server:
Alix 2D3(
http://pcengines.ch/alix2d3.htm ) + CF Card + OpenBSD 5.1:
- adsl 6Mb via pseudo-device pppoe0
- pf(altq+hfsc), queueing(hfsc) for 15 hosts and few services
- NAT(plus natpmpd)
- UniFi Controller(running jre 1.7 and mongodb) for few UniFi access points
- Controlling APC Smart 1000VA via com via apcupsd
- EKG on screen
- irssi for IRC on screen
- twirssi(
http://twirssi.com ) Twitter via terminal
- Simple stats via ipfm(
http://scripfm.sourceforge.net )
- small www server(apache) for few things, next time(OpenBSD 5.2) will be nginx
- ntpd daemon(Alix 2D3 without RTC battery)
- hardware encryption 128bit Cipher aes128-cbc via SoC Geode on Alix
- enable LEDs via gpioctl, LEDs(front panel) blinking right now, looks awesome
5-6watts idle 0dB!
dmesg(OpenBSD 5.1):
Quote:
OpenBSD 5.1-stable (ALIX) #0: Thu Jul 19 09:43:40 CEST 2012
root@xxxxxxxxx:/usr/src/sys/arch/i386/compile/ALIX
RTC BIOS diagnostic error 80<clock_battery>
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) 499 MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX,MMX X,3DNOW2,3DNOW
real mem = 267976704 (255MB)
avail mem = 253497344 (241MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/05/08, BIOS32 rev. 0 @ 0xfd088
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0xa800
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10, address 00:0d:b9:18:c1:50
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034
vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address 00:0d:b9:18:c1:51
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034
vr2 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 15, address 00:0d:b9:18:c1:52
ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034
glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 3, 32-bit 3579545Hz timer, watchdog, gpio
gpio0 at glxpcib0: 32 pins
pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <SanDisk SDCFX3-004G>
wd0: 4-sector PIO, LBA, 3919MB, 8027712 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 12, version 1.0, legacy support
ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 12
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1
isa0 at glxpcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
com1: console
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1
mtrr: K6-family MTRR support (2 registers)
nvram: invalid checksum
vscsi0 at root
scsibus0 at vscsi0: 256 targets
softraid0 at root
scsibus1 at softraid0: 256 targets
root on wd0a (81eaab064a4e09e3.a) swap on wd0b dump on wd0b
clock: unknown CMOS layout
WARNING: clock time much less than file system time
WARNING: using file system time
WARNING: CHECK AND RESET THE DATE!
|
few pix:
