I'm new to FreeBSD, and I'm trying to get it to run on my trashy Acer laptop, but I've run into an issue with the network adaptor: it won't be detected at all unless I run FreeBSD without ACPI. I get this on boot:
mskc0: <Marvell Yukon 88E8038 Gigabit Ethernet> irq 16 at device 0.0 on pci2
mskc0: 0x4000 bytes of rid 0x10 res 3 failed (0, 0xffffffff).
mskc0: unknown device: id=0xff, rev=0x0f
device_attach: mskc0 attach returned 6
Using kldload to load the if_sk driver fails, claiming "file already exists".
How can I work around this? I need my networking capabilities, but a laptop without ACPI is a bit useless for doing stuff on the go.