DaemonForums  

Go Back   DaemonForums > OpenBSD > OpenBSD General

OpenBSD General Other questions regarding OpenBSD which do not fit in any of the categories below.

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1   (View Single Post)  
Old 31st March 2010
mfaridi's Avatar
mfaridi mfaridi is offline
Spam Deminer
 
Join Date: May 2008
Location: Afghanistan
Posts: 282
Thanked 5 Times in 5 Posts
Default can I run fluxbox on pentium 233

I install OpenBSD 4.6 on pentium 233
This is (dmesg; sysctl hw.sensors)

Code:
OpenBSD 4.6 (GENERIC) #58: Thu Jul  9 21:24:42 MDT 2009
    deraadt@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium/MMX ("GenuineIntel" 586-class) 234 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,MCE,CX8,MMX
real mem  = 133787648 (127MB)
avail mem = 120565760 (114MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 12/09/97, BIOS32 rev. 0 @ 0xfb6e0
apm0 at bios0: Power Management spec V1.2 (slowidle)
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xbba8
pcibios0: PCI BIOS has 6 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 9 10 11
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371AB PIIX4 ISA" rev 0x00)
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xc0000/0x8000
cpu0 at mainbus0: (uniprocessor)
cpu0: F00F bug workaround installed
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Intel 82439TX System" rev 0x01
piixpcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x01
pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 1: <QUANTUM FIREBALLlct20 30>
wd0: 8-sector PIO, LBA, 28629MB, 58633344 sectors
wd0(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 2
atapiscsi0 at pciide0 channel 1 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <ASUS, CD-S400/A, 1.9K> ATAPI 5/cdrom removable
cd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
uhci0 at pci0 dev 7 function 2 "Intel 82371AB USB" rev 0x01: irq 11
piixpm0 at pci0 dev 7 function 3 "Intel 82371AB Power" rev 0x01: SMI
iic0 at piixpm0
"eeprom" at iic0 addr 0x50 not configured
spdmem0 at iic0 addr 0x51: 64MB SDRAM non-parity PC100CL3
ne3 at pci0 dev 8 function 0 "Compex Compexe" rev 0x0a: irq 10, address 00:80:48:c3:d5:74
vga1 at pci0 dev 9 function 0 "S3 ViRGE DX/GX" rev 0x01
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
ne4 at pci0 dev 10 function 0 "Compex Compexe" rev 0x0a: irq 9, address 00:80:48:ca:1c:2c
isa0 at piixpcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pmsi0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pmsi0 mux 0
sb0 at isa0 port 0x220/24 irq 5 drq 1: dsp v4.12
midi0 at sb0: <SB MIDI UART>
audio0 at sb0
opl0 at sb0: model OPL3
midi1 at opl0: <SB Yamaha OPL3>
pcppi0 at isa0 port 0x61
midi2 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
usb0 at uhci0: USB revision 1.0
uhub0 at usb0 "Intel UHCI root hub" rev 1.00/1.00 addr 1
biomask e945 netmask ef45 ttymask ffdf
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
I want use it for desktop
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Fluxbox don't start Artur FreeBSD General 4 3rd September 2009 01:04 PM
fluxbox crash? HELP bsdnewbie999 OpenBSD General 9 2nd April 2009 04:35 AM
HOWTO: Fluxbox from GIT vermaden Guides 6 3rd November 2008 12:13 PM
OpenBSD 4.3, XDM + FluxBox WeakSauceIII General software and network 2 19th May 2008 08:34 PM
gtk themes for fluxbox rex FreeBSD General 0 18th May 2008 03:24 AM


All times are GMT. The time now is 09:30 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content copyright © 2007-2010, the authors
Daemon image copyright ©1988, Marshall Kirk McKusick