Cisco IOS commands ??
Since I posted the below question, I bypassed the need for the answer (this year probably). Sorry!
secondhand Cisco router
currently an #ifconfig... and a #route... sets up a .0 network, with the nic as .99, and default gateway .1 (prefixes omitted)
I want to insert the router as
.99 >>> ...new 10.10.x.x. or....>> 871Router >>...exisiting x.x.x.Y ...>>> .1 gw || dsl box || .99 seen outside
50 or so pdfs' and htm's I've saved are not verbose enough AFAIK. I
will know otherwise if I spend a few hours with each one. (maybe)
... "nat only"
...... "pat version of nat"
... "acl rather than nat"
... "acl additionally to nat"
... "dhcp y/n"
routing terms I am unsure of that I need to use in This Setup.
I regret that of the 20 or 50 or so "answersing sites" i've saved
posted the working configuration without enough comments nor
diagrams to explain each command line, about how it relates to
the end result in the network.
SOLVED this year, another router (consumer grade ) happened to work
only a few hours per week to attempt to do the configuration myself, is
why I posted here.
FreeBSD v9... pkg2ng somewhat working...
Last edited by jb_daefo; 5th June 2008 at 01:28 AM. Reason: 2 more lines // THEN// info not urgent anymore // reformatting
|Thread||Thread Starter||Forum||Replies||Last Post|
|Policy routing bsd and cisco||clone||Guides||1||17th August 2009 04:57 PM|
|NetBSD for Cisco Pix?||twoblink||NetBSD General||8||3rd May 2009 11:21 PM|
|No DRI + GLX commands?||Hrr4||FreeBSD General||5||21st September 2008 10:05 AM|
|Cisco Secure ACS 4.1 syslog OpenBSD 3.9||cyberpaisalegionair||OpenBSD General||1||24th July 2008 06:42 PM|
|FreeBSD Administration Commands||corey_james||FreeBSD General||13||10th June 2008 08:44 PM|