ACPI - dmesg
FreeBSD 7.0-RELEASE FreeBSD 7.0-RELEASE #1
I ran dmesg and I found two "failed". Altogether I don't have problems but sometimes computer freezing without errorors. As desktop I use KDE and the Power Managemt is enabled.
Thanks in advance...
ACPI APIC Table: <A M I OEMAPIC >
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
cpu0 (BSP): APIC ID: 0
cpu1 (AP): APIC ID: 1
ioapic0 <Version 2.0> irqs 0-23 on motherboard
kbd1 at kbdmux0
acpi0: <A M I OEMXSDT> on motherboard
acpi0: Power Button (fixed)
acpi0: reservation of 0, a0000 (3) failed
acpi0: reservation of 100000, 1fef0000 (3) failed
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x808-0x80b on acpi0
cpu0: <ACPI CPU> on acpi0
p4tcc0: <CPU Frequency Thermal Control> on cpu0
cpu1: <ACPI CPU> on acpi0
p4tcc1: <CPU Frequency Thermal Control> on cpu1
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
agp0: <Intel 82865 host to AGP bridge> on hostb0
pcib1: <ACPI PCI-PCI bridge> at device 1.0 on pci0
pci1: <ACPI PCI bus> on pcib1
Do you have laptop?
If not, i would disable power management..... (might help, might not)
Even if you have laptop, try disabling power management.
As far as i know, there are problems related to CPU states....
# dmesg | grep fail acpi0: reservation of 0, a0000 (3) failed acpi0: reservation of 100000, 7fef0000 (3) failed
It's not hanging.....
Also what videocard do you use?
and do you have agp compiled in kernel?
Last edited by graudeejs; 9th July 2008 at 09:15 PM.
Yes, I have agp compiled in kernel.
About one hour after I wrote a post I had a poblem as I did described.
idk about ATI drivers (if they ship with agp driver).... i have nvidia card (which does).... and with agp shipped with kernel i had lags, and other problems, which were solved when i compiled kernel without agp.....
at worst you will have to recompile kernel again....
|Thread||Thread Starter||Forum||Replies||Last Post|
|Another ACPI question, 7.2-release||Mantazz||FreeBSD Ports and Packages||1||20th September 2009 11:11 PM|
|How to: DMESG Monitoring||damien-NF||FreeBSD Installation and Upgrading||2||4th August 2009 11:30 PM|
|how APM & ACPI duke it out to be the default||ocicat||OpenBSD General||0||23rd June 2009 04:05 AM|
|strange dmesg output||gosha||OpenBSD General||4||11th March 2009 01:10 PM|
|Properly sending dmesg to dmesg@||twisted_steel||OpenBSD General||5||27th July 2008 02:43 PM|