|
FreeBSD General Other questions regarding FreeBSD which do not fit in any of the categories below. |
|
Thread Tools | Display Modes |
|
|||
Freebsd Ath0 mode monitor
Hello to all of this forum.
With the command "airodump-ng ATH0" enter the interface in monitor mode, as I do for that interface back to its original state without restarting the system? translated from Portuguese Brazil to English with google translator. |
|
|||
in pkg-message.in
Code:
Contrary to Linux, it is not necessary to use airmon-ng to enable the monitor mode of your wireless card. So do not care about what the manpages say about airmon-ng, airodump-ng sets monitor mode automatically. To return from monitor mode, issue the following command: ifconfig ${INTERFACE} -mediaopt monitor For aireplay-ng you need FreeBSD >= 7.0. Last edited by alantis13; 7th April 2009 at 02:20 PM. |
|
|||
Quote:
grateful for the help google translator |
|
|||
from ifconfig(8) use -monitor
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FreeBSD 7.2@amd64 atheros problem ath0: stuck beacon; resetting (bmiss count 4) | asmo | FreeBSD General | 0 | 6th June 2009 11:02 AM |
wlan -> monitor mode | ccc | FreeBSD Security | 2 | 4th November 2008 09:19 PM |
What is best way to monitor for bad sectors? | PeterSteele | FreeBSD General | 9 | 16th August 2008 02:41 AM |
Ath0 + wpa, how configure? | nesca2in1 | FreeBSD General | 10 | 2nd July 2008 04:12 AM |