|
FreeBSD Ports and Packages Installation and upgrading of ports and packages on FreeBSD. |
|
Thread Tools | Display Modes |
|
||||
Are dbus-daemon and hald actually running?
To get them both running at boot time, you must add to /etc/rc.conf: Code:
dbus_enable="YES" hald_enable="YES" Code:
# /usr/local/etc/rc.d/dbus start # /usr/local/etc/rc.d/hald start |
|
|||
Thanks a lot BSDKaffee ... I had the same problem and this seems to have solved at least THAT issue
|
|
||||
First I tried to run BMPx under Openbox and got only the second message. Then I followed BSDKaffe's suggestions (thanks ). As a result the program runs under Openbox without any problem so far, but under XFCE i still have to use
% dbus-launch beep-media-player-2 I must have turned off DBUS support in one of XFCE ports during compillation.
__________________
rtfm Last edited by greencross; 12th September 2008 at 06:40 AM. |
|
||||
I am not familiar with XFCE, but you probably need to adjust your ~/.xinitrc so that a dbus session is available to your applications.
You may want to try an ~/.xinitrc that looks like this: Code:
/usr/local/bin/dbus-launch --sh-syntax --exit-with-session /usr/local/bin/startxfce4 eval `dbus-launch` export DBUS_SESSION_BUS_ADDRESS DBUS_SESSION_BUS_PID |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boot problem. Geometry problem? | gulanito | FreeBSD Installation and Upgrading | 0 | 3rd July 2009 03:03 AM |