|
OpenBSD General Other questions regarding OpenBSD which do not fit in any of the categories below. |
|
Thread Tools | Display Modes |
|
|||
Problem setting up a multiport router!!
Hardware list
Goal
What I am settling with
Before connecting the device directly to the internet; l have it place behind a commercial router. I followed the instructions on http://www.openbsd.org/faq/faq4.html#InstMedia Available network interfaces are: re0 athn0 re1 re2 re3 vlan0. Which one do you wish to configure? (or 'done') [re0] Enter IPv4 address for re0? (or 'dhcp' or 'none') [dhcp] 10.97.1.254 {step followed} IPv6 address for re0? (or 'rtsol' or 'none') [none] fc09::f256 {step followed} Available network interfaces are: re0 athn0 re1 re2 re3 vlan0. Which one do you wish to configure? (or 'done') [done] re1 re1: 10.81.0.254/8 & fc09::f625 re2: skiped re3: dhcp {re2 and re3 would be connected to the internet that's why l didn't configure re2 and set re3 as DHCP} *No DHCPv6 with commercial router My problem!! Available network interfaces are: re0 athn0 re1 re2 re3 vlan0. Which one do you wish to configure? (or 'done') [done] athn0 Here where l need guidance. I want to set this router as an access point (host AP) I need to use 802.11 a/b/g and n set the channel to 8 ESSID: mangoroes wpa : {lets say concorde9concorde9concorde} I looked at http://www.openbsd.org/cgi-bin/man.c...nfig&sektion=8 in vain WRT to the split DNS and DHCP I know it can be achieved on linux but not sure if it can be achieved on Openbsd? Any one can confirm this? Last edited by ocicat; 1st April 2012 at 02:58 PM. Reason: activated links |
|
|||
Unlike Linux, the *BSD world identifies network interfaces via the driver used. In your case, you have indicated having a athn0 interface, so check the examples section in the athn(8) manpage.
Quote:
Last edited by ocicat; 1st April 2012 at 05:50 PM. Reason: fixed missing [b] tag... |
|
|||
Quote:
Code:
The athn driver does not support any of the 802.11n capabilities offered by the adapters. Additional work is required in ieee80211(9) before those features can be supported. Code:
mediaopt hostap media autoselect nwid mangoroes chan 8 wpakey 'blablapass' |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Cable Modem/BSD Router Problem | Dr-D | OpenBSD General | 11 | 2nd April 2012 06:33 PM |
Problem setting up perl modules | badguy | OpenBSD Installation and Upgrading | 4 | 10th August 2009 09:46 PM |
Problem with PORTSNAP and my router | cedcot | FreeBSD Ports and Packages | 2 | 22nd April 2009 11:32 AM |
getting and setting time from router | michaelrmgreen | General software and network | 1 | 5th February 2009 01:58 PM |
Samba 3.0 problem to setting up private folder - FreeBSD 71-pre | bsduser | FreeBSD General | 7 | 27th September 2008 03:34 PM |