![]() |
|
FreeBSD Ports and Packages Installation and upgrading of ports and packages on FreeBSD. |
![]() |
|
Thread Tools | Display Modes |
|
|||
![]()
Hi!
I've installed fusefs-ntfs port today and it broke my FreeBSD 7.0 system. First it rebooted my system twice in attempt to install the port and then after I managed to install it and configuring it reading the /usr/local/share/doc/ntfs-3g/README.FreeBSD file and rebooting it could not mount /usr and it falls into single-user mode asking me to run fsck manually and so I did. fsck prints tons of output asking me [RECONNECT], [CLEAR] some dirs, etc.. Now I'm without my FreeBSD system. What could be the problem that it cannot mount /usr ? Thanks! EDIT1: I've made a fresh minimal install on my system and after that tried to install the fusefs-ntfs port again and it crashed my system one more time ![]() It printed some output about the crash, but I was not able to write down all of it, but this was the first line of the crash: Fatal trap 12: page fault while in kernel mode This was the error or something like that followed by some other lines of output. Does anyone have experienced something like that? EDIT2: I've found this thread: http://freebsd.monkey.org/freebsd-bu.../msg00550.html It is supposed to fix the problem after I remove these options from my kernel, but in fact I don't even have these options in my custom kernel... options DEBUG_LOCKS options DEBUG_VFS_LOCKS Problem remains...
__________________
FreeBSD Handbook - The Power to Serve! Last edited by daemonFromHeaven; 10th September 2008 at 01:36 PM. |
|
|||
![]()
Any tips?
__________________
FreeBSD Handbook - The Power to Serve! |
|
|||
![]() Quote:
http://freebsd.monkey.org/freebsd-bu.../msg00094.html I read the lists about this problem and should be fix when the kernel options I mentioned are removed, but I as said I don't have these options in my custom kernel. I think it must be something with the kernel or with the fusefs-ntfs port... ![]() EDIT: Does anyone of you having a working fusefs-ntfs port compiled it with some extra options and/or have the above kernel options in your kernel config file?
__________________
FreeBSD Handbook - The Power to Serve! Last edited by daemonFromHeaven; 11th September 2008 at 10:38 AM. |
|
|||
![]()
Problem solved. I had to run make buildworld and make installworld to update my userland.
![]()
__________________
FreeBSD Handbook - The Power to Serve! |
![]() |
Tags |
ntfs |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mounting ntfs drive as rw using fusefs-ntfs | caesius | FreeBSD General | 3 | 12th October 2008 11:08 AM |
fusefs-kmod: requires the userland sources to be installed? | zelut | FreeBSD Ports and Packages | 2 | 7th October 2008 10:39 PM |
Cannot mount (NTFS) | IIMarckus | OpenBSD General | 4 | 11th August 2008 08:44 PM |
mount fusefs (sshfs) from fstab | elon | FreeBSD General | 4 | 29th July 2008 06:41 PM |
Problem updating fusefs-kmod | Malakim | FreeBSD Ports and Packages | 6 | 25th July 2008 12:40 PM |