DaemonForums  

Go Back   DaemonForums > OpenBSD > OpenBSD General

OpenBSD General Other questions regarding OpenBSD which do not fit in any of the categories below.

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1   (View Single Post)  
Old 22nd May 2008
reuteler reuteler is offline
New User
 
Join Date: May 2008
Posts: 7
Default hard lock on ifconfig wi0 up

i'm wondering if anyone has any ideas here. i have a lex twister (a via c7) with a mini-pci 802.11 card installed (an intersil prism chipset, shows up as wi0). it's detected and shows up in ifconfig but when i do an ifconfig wi0 up it locks up the system. same for a linksys PCI (not mini-pci) card (ral driver). both these cards worked fine in a soekris box so it seems to be an issue w/ the twister? any ideas?

reuteler@panic,0$ ifconfig wi0
wi0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
lladdr 00:02:6f:4a:d0:24
media: IEEE802.11 autoselect (none)
ieee80211: nwid IBSS chan 1 bssid 44:44:44:44:44:44 -13dBm (auto)
reuteler@panic,0$

here's the dmesg

OpenBSD 4.3 (GENERIC) #698: Wed Mar 12 11:07:05 MDT 2008
deraadt@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: VIA Esther processor 1000MHz ("CentaurHauls" 686-class) 1.01 GHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,P GE,CMOV,PAT,CFLUSH,ACPI,MMX,FXSR,SSE,SSE2,TM,SBF,S SE3,EST,TM2
cpu0: RNG AES AES-CTR SHA1 SHA256 RSA
real mem = 1005023232 (958MB)
avail mem = 963633152 (918MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 12/05/06, BIOS32 rev. 0 @ 0xf9ee0, SMBIOS rev. 2.3 @ 0xf0800 (33 entries)
bios0: vendor Phoenix Technologies, LTD version "6.00 PG" date 12/05/2006
apm0 at bios0: Power Management spec V1.2 (slowidle)
apm0: AC on, battery charge unknown
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xf0000/0xd964
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfd860/240 (13 entries)
pcibios0: bad IRQ table checksum
pcibios0: PCI BIOS has 14 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 3 5 7 10 11
pcibios0: PCI Interrupt Router at 000:17:0 ("VIA VT8237 ISA" rev 0x00)
pcibios0: PCI bus #3 is the last bus
bios0: ROM list: 0xc0000/0xfc00
cpu0 at mainbus0
cpu0: unknown Enhanced SpeedStep CPU, msr 0x08100a1308000a13
cpu0: using only highest and lowest power states
cpu0: Enhanced SpeedStep 1000 MHz (1004 mV): speeds: 1000, 800 MHz
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "VIA CN700 Host" rev 0x00
agp0 at pchb0: v3, aperture at 0xe0000000, size 0x10000000
pchb1 at pci0 dev 0 function 1 "VIA CN700 Host" rev 0x00
pchb2 at pci0 dev 0 function 2 "VIA CN700 Host" rev 0x00
pchb3 at pci0 dev 0 function 3 "VIA PT890 Host" rev 0x00
pchb4 at pci0 dev 0 function 4 "VIA CN700 Host" rev 0x00
pchb5 at pci0 dev 0 function 7 "VIA CN700 Host" rev 0x00
ppb0 at pci0 dev 1 function 0 "VIA VT8377 AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "VIA S3 Unichrome PRO IGP" rev 0x01
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
em0 at pci0 dev 5 function 0 "Intel PRO/1000MT (82541GI)" rev 0x05: irq 10, address 00:30:18:4a:a4:ac
em1 at pci0 dev 6 function 0 "Intel PRO/1000MT (82541GI)" rev 0x05: irq 11, address 00:30:18:4a:a4:ad
em2 at pci0 dev 7 function 0 "Intel PRO/1000MT (82541GI)" rev 0x05: irq 7, address 00:30:18:4a:a4:ae
em3 at pci0 dev 8 function 0 "Intel PRO/1000MT (82541GI)" rev 0x05: irq 5, address 00:30:18:4a:a4:af
wi0 at pci0 dev 9 function 0 "Intersil PRISM2.5" rev 0x01: irq 3
wi0: PRISM2.5 ISL3874A(Mini-PCI) (0x8013), Firmware 1.1.0 (primary), 1.4.9 (station), address 00:02:6f:4a:d0:24
cbb0 at pci0 dev 10 function 0 "Ricoh 5C476 CardBus" rev 0x8b: irq 11
cbb1 at pci0 dev 10 function 1 "Ricoh 5C476 CardBus" rev 0x8b: irq 10
pciide0 at pci0 dev 15 function 0 "VIA VT6420 SATA" rev 0x80: DMA
pciide0: using irq 11 for native-PCI interrupt
wd0 at pciide0 channel 0 drive 0: <ST98823AS>
wd0: 16-sector PIO, LBA48, 76319MB, 156301488 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
pciide1 at pci0 dev 15 function 1 "VIA VT82C571 IDE" rev 0x06: ATA133, channel 0 configured to compatibility, channel 1 con
figured to compatibility
pciide1: channel 0 disabled (no drives)
pciide1: channel 1 disabled (no drives)
uhci0 at pci0 dev 16 function 0 "VIA VT83C572 USB" rev 0x81: irq 10
uhci1 at pci0 dev 16 function 1 "VIA VT83C572 USB" rev 0x81: irq 10
uhci2 at pci0 dev 16 function 2 "VIA VT83C572 USB" rev 0x81: irq 11
uhci3 at pci0 dev 16 function 3 "VIA VT83C572 USB" rev 0x81: irq 11
ehci0 at pci0 dev 16 function 4 "VIA VT6202 USB" rev 0x86: irq 7
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "VIA EHCI root hub" rev 2.00/1.00 addr 1
viapm0 at pci0 dev 17 function 0 "VIA VT8237 ISA" rev 0x00
iic0 at viapm0
spdmem0 at iic0 addr 0x50: 1GB DDR2 SDRAM ECC PC2-4200CL3
auvia0 at pci0 dev 17 function 5 "VIA VT8233 AC97" rev 0x60: irq 7
ac97: codec id 0x56494161 (VIA Technologies VT1612A)
ac97: codec features headphone, 18 bit DAC, 18 bit ADC, KS Waves 3D
audio0 at auvia0
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 2 device 0 cacheline 0x0, lattimer 0x20
pcmcia0 at cardslot0
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 3 device 0 cacheline 0x0, lattimer 0x20
pcmcia1 at cardslot1
usb1 at uhci0: USB revision 1.0
uhub1 at usb1 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb2 at uhci1: USB revision 1.0
uhub2 at usb2 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb3 at uhci2: USB revision 1.0
uhub3 at usb3 "VIA UHCI root hub" rev 1.00/1.00 addr 1
usb4 at uhci3: USB revision 1.0
uhub4 at usb4 "VIA UHCI root hub" rev 1.00/1.00 addr 1
isa0 at mainbus0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
viasio0 at isa0 port 0x2e/2: VT1211 rev 0x02, HM, WDG not activated
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
biomask ffc5 netmask ffed ttymask ffef
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
MYSQL can't start "UNABLE TO LOCK disappearedng FreeBSD General 0 14th October 2008 02:01 AM
need some basic help on ifconfig daemon-dd FreeBSD General 4 29th July 2008 03:21 PM
FreeBSD's Ifconfig for WEP tz24 FreeBSD General 15 13th June 2008 02:17 AM
ifconfig problem ichigo OpenBSD General 3 20th May 2008 10:59 PM
acpiconf -s3/-s4 lock up the system. caesius FreeBSD General 5 10th May 2008 10:44 PM


All times are GMT. The time now is 01:21 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Content copyright © 2007-2010, the authors
Daemon image copyright ©1988, Marshall Kirk McKusick