|
FreeBSD General Other questions regarding FreeBSD which do not fit in any of the categories below. |
|
Thread Tools | Display Modes |
|
|||
Marvell Yukon driver cannot load with ACPI enabled
Hi folks,
I'm new to FreeBSD, and I'm trying to get it to run on my trashy Acer laptop, but I've run into an issue with the network adaptor: it won't be detected at all unless I run FreeBSD without ACPI. I get this on boot: Code:
mskc0: <Marvell Yukon 88E8038 Gigabit Ethernet> irq 16 at device 0.0 on pci2 mskc0: 0x4000 bytes of rid 0x10 res 3 failed (0, 0xffffffff). mskc0: unknown device: id=0xff, rev=0x0f device_attach: mskc0 attach returned 6 How can I work around this? I need my networking capabilities, but a laptop without ACPI is a bit useless for doing stuff on the go. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Marvell 88E8038 ethernet adaptor doesn't work with NetBSD 5, even with ACPI disabled | GullibleJones | NetBSD General | 2 | 13th December 2009 10:55 AM |
Trouble with ftp with pf enabled | kasse | FreeBSD General | 8 | 24th August 2008 11:25 PM |
Problem using pkg with pf enabled | aleunix | FreeBSD Security | 2 | 25th July 2008 11:43 PM |
NVIDIA driver fails to load, freebsd 7.0 | mc_i2020 | FreeBSD General | 18 | 18th July 2008 01:12 PM |
Using FreeBSD Marvell Driver | vi5in | FreeBSD General | 0 | 12th May 2008 11:16 PM |