|
NetBSD General Other questions regarding NetBSD which do not fit in any of the categories below. |
|
Thread Tools | Display Modes |
|
|||
Marvell 88E8038 ethernet adaptor doesn't work with NetBSD 5, even with ACPI disabled
I ran into an annoying situation with NetBSD 5 (installed via Jibbed):
My Marvell 88E8038 appears as msk0. However, running dhcpcd on it always times out, and I can't seem to get a connection at all. No unusual messages appear in dmesg... Anyone know what this is? With ACPI disabled, this card used to work... (FWIW: with ACPI disabled, the ethernet controller doesn't appear at all. This is due to limitations in my laptop's BIOS; there's nothing I can do about it, except maybe get APM working.) |
|
|||
What length staples should I use on a staple gun for ethernet cables? I want to know the recommended staple length I need to use on a staple gun for putting ethernet cables on the wall/floor.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fluxbox-generate_menu doesn't work | nihonto | NetBSD Package System (pkgsrc) | 4 | 5th April 2022 03:03 PM |
ln -f at boot doesn't work | lordyan | OpenBSD General | 3 | 19th February 2009 03:50 PM |
NetBSD pre-release 5 doesn`t boot | welkin | NetBSD Installation and Upgrading | 4 | 6th January 2009 10:13 PM |
Marvell Yukon driver cannot load with ACPI enabled | GullibleJones | FreeBSD General | 2 | 15th September 2008 02:58 PM |
KDE (X-Server) in FreeBSD 7.0 doesn't work correctly | louie | FreeBSD General | 6 | 7th May 2008 11:53 PM |