|
FreeBSD General Other questions regarding FreeBSD which do not fit in any of the categories below. |
|
Thread Tools | Display Modes |
|
|||
Took hardisk out and replaced to another machine: CAN"T Mount
Hi everyone.
I took out the harddisk of my computer and placed it into a new one. When I ran Freebsd 7.0 on it, I get a the following error: can't stat /dev/ad4s2e: No such file or directory can't stat /dev/ad4s2d: No such file or directory can't stat /dev/ad4s2f: No such file or directory because my old computer keeps rebooting half way and I think that my FreeBSD partition has been damaged because of that. I have looked into a few sources and decided to run fsck to check. Upon entering fsck, I get errors such as fsck -p /dev/ad0s2c No write access /dev/ad0s2c unexpected inconsistency; run fsck manually So I have decided to boot into single user mode. However, this is difficult for me because normal boot will cause my system to crash. I can only boot with acpi disabled but when I boot into single user mode, I am getting the similar crash as the system inidicates: GEOM_Label for provider ad4s1 is ntfs/MAX_Software and then the computer freezes: I think that my harddisk may have a few bad sectors, and this is causing the system to crash when it loads the geom_label line to the screen. Aside from reformatting, how do I do the following: 1) Run fsck or similar or any tools that I can burn to a cd to check for bad sectors on my harddisk? 2) Rebuild my /etc/fstab 3) Edit the manual so that my FreeBSD system always start with ACPI disabled 4) log into single user mode with ACPI disabled? Any help will be appreciated. I am really lost. Thx |
|
||||
put it back in the old pc or use a livecd or use a boot disk (typically a floppy or install cd)
???
__________________
My Journal Thou shalt check the array bounds of all strings (indeed, all arrays), for surely where thou typest ``foo'' someone someday shall type ``supercalifragilisticexpialidocious''. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fixed "xinit" after _7 _8, "how" here in case anyones' "X" breaks... using "nvidia" | jb_daefo | Guides | 0 | 5th October 2009 09:31 PM |
How to "configure" and mount a USB Drive already in use | IronForge | OpenBSD General | 10 | 1st September 2009 05:36 PM |
"Thanks" and "Edit Tags". | diw | Feedback and Suggestions | 2 | 29th March 2009 12:06 AM |
Newbie-friendly "printing in OpenBSD" guide wanted | Shagbag | OpenBSD Packages and Ports | 5 | 7th July 2008 09:26 PM |