10.3-RELEASE installer and partitioning - what goes on under the hood?
just popping over from the OpenBSD part of the forum
I'd like to install 10.3 from USB but I'm not 100% sure about the partitioning step. Let me elaborate:
Installer boots fine, at the Partitioning screen I choose
So far, so good. Then I reach the Partition Editor's rewiew screen:
(FreeBSD Handbook, Chapter 2.6.2, Figure 2.15. "Review Created Partitions")
In my case the screen above shows all devices and their partitions: ada0 da0 da1 (hardrive and two USB thumb drives respectively). da0 contains the freshly created partition table for the FreeBSD install, just as it should.
It's the next step I'm unsure about:
(FreeBSD Handbook, Chapter 2.7, Figure 2.26. "Committing to the Installation")
|Thread||Thread Starter||Forum||Replies||Last Post|
|Partitioning schemes||geek||OpenBSD General||7||30th March 2016 09:58 PM|
|MBR GPT hybrid partitioning||J65nko||FreeBSD Installation and Upgrading||2||16th November 2011 09:37 AM|
|FBSD installer took away all control ...||sharris||FreeBSD Installation and Upgrading||17||12th July 2011 06:55 PM|
|Partitioning for web/mailserver?||DrKrall||OpenBSD Installation and Upgrading||3||20th November 2009 01:14 PM|
|booting vista installer dvd||bsdnewbie999||Other OS||9||15th October 2008 06:16 PM|