|
|
|||
ipsec.conf & IKE mode config
isakmpd.conf supported IKE mode config (IKECFG-ID), but I'm not finding any mention of it for ipsec.conf.
Does anyone know if the ipsec.conf way of configuring an IPSec VPN supports IKE mode config? If it does, could you please point me in the right direction. If not, what would be the recommended method for pushing network settings to a road-warrior (dhcp over ipsec, go back to isakmpd.conf)? Thanks! |
|
|||
the right direction will be the man pages there is no mention on ipsec.conf becose this is another way to do the same things isakmpd man pages mention about ike wich is the ike v1 protocol the iked is under development and it implements ikev2 and the point about the road warrior with ipsec its manages with the any keyword it is on the man page like
ike active esp from any to $mynet peer any bla bla bla |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Where should I put my config? "rc.conf" or "rc.conf.local"? | fender0107401 | OpenBSD General | 2 | 2nd April 2012 02:53 AM |
Sun XVR-600 in 24-bit mode | Don_HH2K | OpenBSD Installation and Upgrading | 2 | 30th June 2010 08:06 PM |
no-tab-mode in mg? | Sunnz | OpenBSD General | 0 | 10th March 2010 12:10 PM |
wlan -> monitor mode | ccc | FreeBSD Security | 2 | 4th November 2008 09:19 PM |
difference between rc.conf and loader.conf | disappearedng | FreeBSD General | 5 | 3rd September 2008 05:54 AM |