Mounting ext2 partitions seems to fail
I have a fresh installation of FreeBSD 7.2 on my box.
I am simply trying to mount the ext2 partitions on an hard drive.
The hard drive is recognized, the partitions and the file system as well.
mount -t etx2fs /dev/partition /mounting/point
df -h indicates that the partition is mounted and ready to use then.
But... the mounting point is then a file and not a folder anymore!
So I can not do anything with it more or less.
the command ls -al returns a "bad file descriptor" error.
I tried to umount it and it appears as a folder again.
Does anyone know why this is happening?
Last edited by Sunsawe; 16th June 2009 at 10:44 PM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|DHCP Cable Connection Fail||fmgil||OpenBSD General||4||1st September 2009 05:18 PM|
|ext2 lost+found||gosha||General Hardware||0||21st June 2009 01:32 PM|
|Basic networking fail.||diw||OpenBSD General||13||31st March 2009 09:29 AM|
|RAID-1 over NFS with fail-over||PatrickBaer||FreeBSD General||0||12th October 2008 12:03 AM|
|Mounting ext2 in fstab||latorion||FreeBSD General||3||6th August 2008 04:56 PM|