![]() |
|
Feedback and Suggestions We want to hear your thoughts and ideas! |
![]() |
|
Thread Tools | Display Modes |
|
|||
![]()
Presently:
Quote:
|
|
|||
![]()
From the Netherlands, I can access that URL without any issue ....
__________________
You don't need to be a genius to debug a pf.conf firewall ruleset, you just need the guts to run tcpdump |
|
|||
![]()
I used it in this thread:
http://daemonforums.org/showthread.php?t=11949 with this invocation: Code:
The command wpa_passphrase(8) takes your SSID My router (192.168.1.1) is setup for Cloudflare (1.1.1.1) and Google DNS (8.8.4.4) servers, computers on my network reference my router for DNS. I'll test by adding additional nameservers to /etc/resolv.conf and edit back. Code:
$ cat /etc/resolv.conf lookup file bind nameserver 192.168.1.1 nameserver 1.1.1.1 nameserver 8.8.4.4 Last edited by shep; 1st December 2021 at 02:14 PM. |
|
|||
![]()
When I select the wpa_passphrase(8) link in my post, a new tab opens with the following message which I copy/pasted:
Quote:
Last edited by shep; 1st December 2021 at 02:10 AM. |
|
||||
![]()
When I click the link with netbsd.gw.com in it, it fails (as it should, as noted by jggimi).
When people noted a working link, I think it was the one in the first post containing man.netbsd.org. So I think that clarifies the responses. But the question is why the bad link arises from the BB code? |
|
|||
![]()
Yes, my question. I have no firewall and tested w/ Iridium, Firefox-esr and vimb (webkitgtk4) browsers in OpenBSD 7.0. Also tested w/ vimb and Firefox-esr in Crux Linux. I have not set up a firewall and have explicitly set no-proxy for both Firefox and Iridium.
|
|
||||
![]()
So here is an independent test with the BB code in the thread title used to make a link:
wpa_passphrase(8) ... and the link contains netbsd.gw.com . (Done with Seamonkey on Slackware.) I think the problem is with the forum's BB code programming. Last edited by IdOp; 1st December 2021 at 07:32 PM. Reason: various |
|
|||
![]() |
|
|||
![]()
__________________
You don't need to be a genius to debug a pf.conf firewall ruleset, you just need the guts to run tcpdump Last edited by J65nko; 2nd December 2021 at 01:37 AM. |
|
|||
![]()
Thanks for listening
|
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
reset the password of a non-admin user under the Gnome | philo_neo71 | OpenBSD Packages and Ports | 7 | 22nd August 2019 11:00 AM |
unable to reset hardware; hal status on wpa error | sepuku | OpenBSD General | 8 | 10th July 2011 02:25 PM |
SourceForge applies global password reset after hack attack | J65nko | News | 0 | 31st January 2011 02:20 PM |
Cannot reset hardware ath0 | Kkb8 | OpenBSD Installation and Upgrading | 3 | 8th October 2010 04:42 PM |