|
|
|||||||
| FreeBSD Installation and Upgrading Installing and upgrading FreeBSD. |
 |
|
|
Thread Tools | Display Modes |
2nd July 2009
|
|||
|
|||
FBSD 7.2 installation not seeing partition table correctly
I am attempting to upgrade my dual-booting laptop from running XPPro and Kubuntu Linux 9.04 to instead run XPPro and FBSD 7.2-Release. I already used "fixmbr" in XPPro to wipe out the MBR. In windows I now see two partitions (on my 250gb HD) that I use for windows:
39.06G : Windows (NTFS, primary partition) 4.00G : Windows Swap (NTFS, logical drive) Windows disk manager sees then 189.82 gb free at the end of the drive. However when I start FreeBSD installation it sees two windows partitions, which use up the entire drive. Will this be a problem later? I suppose for now I can wipe out the swap partition since I can always go back and re-create it. 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| startx not starting correctly - XOrg 7.4_2 | Mantazz | FreeBSD Ports and Packages | 1 | 8th July 2009 04:17 PM |
| I think I just mangled my partition table | Mantazz | FreeBSD Installation and Upgrading | 2 | 2nd July 2009 09:55 PM |
| freebsd 7 installation partition size for 250gb harddrive | ijk | FreeBSD Installation and Upgrading | 17 | 20th October 2008 07:50 PM |
| How to copy FBSD installation from one which is already installed on a HDD? | padmanabh | FreeBSD Installation and Upgrading | 2 | 7th October 2008 04:09 AM |
| VNC not viewing correctly | disappearedng | FreeBSD General | 6 | 30th August 2008 05:03 PM |
Linear Mode
