|
OpenBSD General Other questions regarding OpenBSD which do not fit in any of the categories below. |
|
Thread Tools | Display Modes |
|
|||
Problem with axe driver?
Greetings all,
I have a USB to RJ-45 adapter with ASIX AX88772B chip, which is correctly recognized, based on the fact that the axe driver is attached. The adapter can be configured via hostname.axe0, and ifconfig show that the configuration is accepted and the status is active. However, there is no connectivity. The dmesg correctly recognize the adapter and its chip, but also report: Code:
axe0: usb errors on rx: IOERROR Kindest regards, M |
|
|||
Hi jggimi,
thank you for your reply. Unfortunately, neither Code:
# infonfig axe0 debug Code:
# ifconfig axe0 -debug In addition, there is no file /var/log/messages to inspect. Should I create it? Kindest regards, M |
|
|||
Hi jggimi,
thank you, but please do not spend so much time on this. I am not sure about your advice. As the hostname.if(5) explains, the content of /etc/hostname.axe0 is read and the arguments found there are passed to to ifconfig(8). Since ifconfig(8) accepts the debug parameter, I added it into the file, which now contains Code:
inet XXX.XXX.XXX.XXX YYY.YYY.YYY.YYY debug Code:
ifconfig: debug: bad value BTW, the syslog(3) still complains that file /var/log/messages does not exist. Kindest regards, M |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VMT driver (VMware Tools driver) on OpenBSD 4.8 | xinform3n | OpenBSD General | 7 | 9th December 2010 10:48 PM |
Which mouse driver | Mr-Biscuit | NetBSD General | 0 | 9th June 2010 12:43 AM |
msk(4) Driver | indienick | FreeBSD General | 4 | 4th May 2009 04:51 PM |
Intel ATOM D945GCLF onboard LAN driver-card problem | mona | FreeBSD Installation and Upgrading | 7 | 17th December 2008 04:50 PM |
X Radeon driver | sum | FreeBSD Installation and Upgrading | 5 | 28th September 2008 03:49 PM |